Information about MICROMASTER is also available from: Regional Contacts .. change this parameter setting in all three inverter states. 4. P-Group. Siemens AG MICROMASTER. // Inverters. kW to kW. Catalog DA / The products and sys- tems described in this. Siemens Micromaster (MM) Series AC Frequency Inverter for kW ( HP) V 3 Ph motor in VxF control to 3A. Simple set-up and ready to run from.
|Published (Last):||25 January 2014|
|PDF File Size:||5.37 Mb|
|ePub File Size:||17.21 Mb|
|Price:||Free* [*Free Regsitration Required]|
Check that the cable length limits have not been exceeded 3. Change value of P 2. As a result, some functions may not work correctly, because there is no normal load condition. P motor i2t time constant should be set to appropriate value 2. Analogue Output parameters should not be set to the same value as each other. Mm has A and F even without a sign for this kind of alarm…How micrmaster remove A and F alarm?
Pulse frequency must be set to default value 3. Check loading on motor 3. View our Micromaster Drives in stock. A blog we posted earlier this week about the Micromaster troubleshooting referenced the Faults and Alarms list for the Micromaster series, so we decided that it would make sense to make the list of Micromaster Faults and Alarms directly available.
NOTE To reset the fault code, one of three methods listed below can be used: Analogue input parameters should not be set to the same value as each other. Check motor data 2. Motor power P must match inverter power P Heatsink temperature and thermal junction model are outside micromater allowable range.
I need help to resolve our MM inventor problem. Check if ambient temperature is within specified limits 2.
Parameter settings for input do not correspond to ADC type Analogue input parameters should not be set to the same value as each other — A DAC parameters not set properly DAC parameters should not be set to identical values, since this would produce illogical results. For more information or to request a quote, please call or email sales mroelectric.
Input voltage P lies within range? Our MM flashes between 6 and 00 when it should flash between 1 and No setpoint received from communications board during telegram off time.
Run self test routines 2.
Check whether the motor parameters correspond with the motor being used 5. We have checked the motor settings and reset some parameters but the incorrect flashing screen is defeating us.
Siemens Micromaster kW V AC Inverter Drive, No Filter – AC Inverter Drives (V)
Fan must turn when inverter is running 2. Reduce the boost 8. Check the stator resistance 6. Cycle the power to the drive.
Siemens Micromaster 420 4kW 400V 3ph AC Inverter Drive, C3 EMC
Hi all I have fault F on micromaster Check whether the motor is obstructed or overloaded. Check whether the motor power corresponds to the inverter power 2.
Increase the ramp-up-time 7. Vdc max controller is active; so ramp- down times will be increased automatically to keep DC-link voltage r within limits P Please how to replace motor of dishwasher Siemens lady Motor parameters must match the motor in use 5.
Siemens Micromaster 420 1.1kW 400V AC Inverter Drive, No Filter
Ramp-down time P must match inertia of load. Check parameter for motor I2t warning level. Check motor cable and motor for short- circuits and earth faults 4.