Figure —Armature reaction. Now you have two fields — the main field, view A, and the field around the armature coil, view B. View C of figure shows . These interpoles, being midway between main poles, are just opposite the The interpole windings are connected in series with the armature. Stator of a DC machine. ▫ Stator is the stationary part. ▫ Main poles as field winding. ▫ Further windings. ▫ Interpole. ▫ Compensation eliminate unwanted effects.
|Published (Last):||15 July 2009|
|PDF File Size:||16.53 Mb|
|ePub File Size:||1.49 Mb|
|Price:||Free* [*Free Regsitration Required]|
The following information provides a summary of the main subjects for review.
Navy Electricity and Electronics Training Series (NEETS), Module 5, through – RF Cafe
The inductance of the coil tends to retard the interplle of the coil current by generating a prolonging voltage and the interpoles must have sufficient additional strength to neutralize this inductive voltage. It is not necessary to shift the brushes when there is an increase or decrease in load. Pages through The proper division of surge current can be obtained by inserting, in series with the interpole shunt, a conductor wound around an iron core to form an inductance just equal to that of the interpole coils.
Its primary purpose was to provide me with ready access to commonly needed formulas and reference material while performing my work as an RF system and circuit design engineer. Such an improper division would cause the interpole field to fail to rise in proportion to the armature current to be commutated, and would probably cause the commutator to flash over at the brushes.
LOAD on a motor interpoe the physical object to be moved by the motor. To limit armature current until counter EMF builds up. It may then be removed after counter EMF has been built up.
interpoole Motor will slow down. The inductance of the coil tends to retard the reversal of the coil current by generating a prolonging voltage. The brushes are located on the no-load neutral plane.
Direction of armature current, and direction of magnetic flux in field. See the editorial for more information Increasing the armature circuit resistance decreases motor speed.
To avoid the commutation difficulty actually encountered in old-style generators, narrow poles called interpoles or commutating poles are windongs, as indicated in Fig. Kimberly To avoid the commutation difficulty actually encountered in old-style generators, narrow poles called interpoles or commutating poles are used, as indicated in Fig. Shunt-motor speed varies only slightly with changes in load, and the starting torque is less than that of other types of DC motors.
Electrical Engineering onterpole a free introductory textbook to the basics of electrical engineering. In fact, most DC generators can be made to act as DC motors, and vice versa. By winding the armature in a way that places the entire coil where it is exposed to maximum flux.
What current flows in the interpole windings? As the load varies, the interpole flux varies, and wlndings is automatically corrected as the load changes.
High torque turning force at low speed. Its speed varies widely between full-load and no-load. When its speed is reduced by a load, the series motor develops greater torque. Automatic starters are not covered in detail in this module. Therefore, the interpole still has the proper polarity to provide automatic commutation. interople
All about EEE: What is the function of interpoles and how are its winding connected?
Nearly all DC motors have drum-wound armatures. In practice the interpoles are made stronger than just sufficient to neutralize the armature flux, in order to aid in the reversal of current in the coils being commutated. It must have a load connected to avoid damage from excess speed.
These interpoles, being midway between main poles, are just opposite the armature poles shown in Fig. If their polarities be made the same as those of the armature poles opposite to them, and if their strength be made equal to that of the armature poles, then the distortion of the main field at the commutating point, as in Fig.
By reversing either field or armature connections. Its starting torque is greater than other types of DC motors.