DAC 8-bit P Compatible, Double-buffered D to A Converters. The is an advanced CMOS/Si-Cr 8-bit multiplying DAC designed to interface directly with the. DAC datasheet, DAC circuit, DAC data sheet: NSC – 8-Bit P Compatible, Double-Buffered D to A Converters,alldatasheet, datasheet, Datasheet. DAC Datasheet, DAC PDF, DAC Data sheet, DAC manual, DAC pdf, DAC, datenblatt, Electronics DAC, alldatasheet, free.
|Published (Last):||9 February 2005|
|PDF File Size:||8.98 Mb|
|ePub File Size:||18.71 Mb|
|Price:||Free* [*Free Regsitration Required]|
DAC Technical Data
DAC takes in parallel 8 bit data from a microcontroller or microprocessor datasheeh converts that data in to analog signal at the output.
DAC also designed with silicon-chromium R-2R resistor ladder network which divides the reference current and provides the circuit with excellent temperature tracking characteristics 0. Submitted by admin on 21 November For working of device DAC we have connected a voltage source of 15V as shown in diagram.
We can use the circuit to develop applications without worry as the circuit is tested working. The device is specifically datasheft for it to be interfaced directly with the,Z80, and other popular microprocessors.
The device is available in the market for low cost and can be easily worked with.
The design also includes special circuitry that provides TTL logic input voltage level compatibility. Double buffering of the device allows outputting a voltage corresponding to one digital word while holding the next digital word.
The chip is ddatasheet with CMOS technology to achieve low power consumption and low output leakage current errors.
DAC0831 PDF Datasheet浏览和下载
So the device is used for converting 8 bit parallel digital data input to analog signal output. This analog signal is the current quantity that is directly proportional to the input digital value and this current parameter needed to dac083 converted in to voltage parameter for further use.
This op-amp circuit is called current-to-voltage converter. All these control pins need to be setup appropriately as mentioned above for successful DAC conversion of the device. Pin Configuration DAC is a twenty pin device and description for each pin is given below.
TL — Programmable Reference Dax0831. This also permits the simultaneous updating of any number of DACs. So to convert the current parameter in to voltage parameter we will use op-amp circuit as shown in circuit diagram.
Now for understanding the working let us consider the example application circuit given in the datasheet. The analog voltage output from the op-amp circuit is in direct relation with inputted digital value and hence DAC conversion with DAC is achieved. Dattasheet IC basically used in applications where an 8 bit digital data needed to be converted to analog value.